It picks up digital TV even if the signal is weak, thanks to its ultra-sensitive reception technology. Fill in the information like this (using the example IP here but 127.0.0.1 will also work).PCTV nanoStick is a gem of a USB DVB-T tuner. Click Settings->Add-on Browser->My add-ons->PVR clients->Tvheadend HTSP Client->Configure. The final step is to enable the TVHeadend HTSP Client in Kodi. This can be set for all users in Configuration->General. In order to see it, you have to enable Advanced or Expert View. You may like to look at the tab EPG Grabber Modules to enable suitable EPG grabbers. To remove channels you don’t want to watch, go to Configuration->Channel/EPG->Channels. When you click Save & Next you are all done with the wizard. It is easiest to map them all at first, then you can disable the channels you don’t want later. Then you have to map the channels you want to watch. The wizard now tells TVHeadend to scan for channels. See post 3 below.įor OTA TV, pick your local transmitter from the drop-down list. If you select the Realtek tuner you may have to resort to the commandline to change it later - so be careful. The Realtek tuner does not support DVB-T2 so leave the Network type empty for that tuner and just select DVB-T Network for the other tuner (Panasonic, or Sony in later versions of the OSMC dongle). You should use one or the other, but not both. Important: the OSMC dongle has two DVB-T tuners. If you don’t see a list of TV adapters in the main screen then your adapter has not been recognised. Specify the type of networks you are going to use.

If this is the first time you have installed TVHeadend, a wizard should start and you will see the following screens in turn:

Use osmc as both the username and password to log on. As an example we will assume it is 192.168.1.99.įrom any other machine on your network, open a browser and navigate to 192.168.1.99:9981. From the Home screen, select Settings->System info->Network and make a note of the IP address. Now you have to configure TVHeadend to tell it which frequencies to listen to. Click Apply in the bottom right corner and you should get a message ‘Operations successfully completed’. Make sure your device is connected to the internet and install TVHeadend from the AppStore by selecting MyOSMC->AppStore (the shopping trolley icon). Plug the tuner into a USB port and attach a good aerial or cable connection. OSMC provides a USB tuner in the online Store, the TVHeadend server and the TVHeadend HTSP client to do all this.

an addon for Kodi which interfaces Kodi to the server.

software ‘server’ to handle the tuning, retrieve OTA EPG and act as a PVR.

a TV tuner attached via USB or a networked TV box.

To watch broadcast (OTA or cable) TV on your OSMC device you need these:

Dose kodi support usb tv antenna